iPod Touch, iPhone 3GS, GameBoy 3DS University

 

Step 1

Remove the camera and flash holes. They should come right out with a little help from a fingernail, push-pin, or even by folding the whole decal just a LITTLE.

Once removed... toss 'em!!!

Make sure they aren't stuck to your finger before proceeding. They have a nasty little habit of sticking to the underside of the decal when applying it. You've been warned!

 

Step 2

Peel the rest of the decal out. (This might be the easiest thing you do all day)

Clean the surface where the decal will be placed. If your hands are clean, gently rip that sucker off the card! You might feel a slight bit of resistance towards the bottom. Thats 100% normal.

Step 3

We start by taking the decal in both hands and start to line it up with the camera/flash holes as our point of origin. It should be center with both holes lined up, with the ever so slightest amount of black (or original phone color) peeking out of the sides.

Once you've aligned those stars, make sure the long and short edges have an equal amount of edge running down the sides. If they do, you are golden. You're almost ready!

If they don't, you can always lift up the decal and try again. Our vinyl is really very forgiving and can withstand more than a couple of tries.

Step 4

Time to close the show!

If you've made it this far, the hard part is over. I wanted to tell you earlier but you were doing so well.

Use your thumbs to lay the rest of the decal down. Start at the top and work your way down. If you can apply even pressure throughout, you won't have any air bubbles when you are finished.

If you see no air bubbles, go show off to your friends, play outside, avoid doing hard work, or any combination of enjoyable activities.